Welcome to the Deep Connect Pico Setup Guide In this video you will learn how to setup.
You can configure pico in one of its three possible modes if you have a modem and router.
Pico-in Mode 1 Virtual Wire Easily connect the included USB-C to Pico-to-Ethernet cables.
And your modem as well as your router then connect the included power cable and then you should.
Watch as the pico starts to glow blue then red and once the color changes to a solid blue pico.
Ready to go If you have an integrated modem and router, you can set up Pico in router mode.Using the included Wi-Fi adapter the Pico becomes a Wi-Fi hotspot for all your devices to connect to.
Connect the antenna to the pico side as shown.Then connect the USBC to the Ethernet cable between the pico and your connected modem and router.
Plug in the power cable after which you should see a single string of LEDs flashing once.
You should see a new Wi-Fi network solid blue with Dark Wi-Fi as part of the Connect name.
Any devices on this network with a default password I love and enjoy everything.
Pico offers that you can access the AtomOS administration page by entering 168.192.1.
In the connected device's browser if you want to use Pico on the go or anywhere
With a Wi-Fi network you can set the Pico in relay mode using the included Wi-Fi adapter.
Pico can connect to a Wi-Fi network and relay it to any connected devices.You can even power the Pico from a laptop USB port so you can use it wherever you go.Set up the device Connect the antenna to the side of the pico and then plug in the power cable and wait.
For the same sequence of blinking LEDs once you see a solid blue icon for a Wi-Fi network.
Deep Wi-Fi Connect to this network with a default password as part of the name
And then you have to access AtomOS administration page by entering 168.192.1.1.
When you have it, you need to connect the Picot to a Wi-Fi network in the area through this interface.
After logging in with the default username and password, go to the Admin Wi-Fi page
It will show your current network mode as well as a list of Wi-Fi networks that have been detected.
At Pico you can press Scan to refresh the list and choose the network you want to connect to.
Type the password and wait a few moments for Picot to complete connecting.
Once done you are ready to use the device.
If you run into any issues during or after setup, check out our Knowledge Base FAQ for help.
You can contact us directly on our official tech support email or through our various social media.
With the platforms we hope you will enjoy a more secure private and fair internet with deep connect pico.
Comments
Post a Comment